Installation Guide

Installation Instructions
1 | P a g e v 1 . 0
MATTEO
SKU# 011350, 011351, 011352
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.
Warranty
• This light fitting is covered by a 12 month warranty. The warranty is from date of purchase, not the date of installation.
• If the fitting is not installed by a licensed electrician the warranty will be void.
• Please retain proof of purchase and evidence of installation by a licensed electrician.
• Warranty will be void if there is any damage due to improper usage or modification to the fitting.
• Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.
Installation requirements
• Must be installed by a licensed electrician.
• All wiring and installation of the light fitting must adhere to local and national wiring rules.
eg. AS/NZS 3000:2007/Amendment 2:2012 Electrical installations.
• Do not exceed the maximum wattage rating.
• Select a suitable location for installation:
- This product is suitable for indoor use only.
- The mounting point must support 2 times the weight of the fitting.
- Ensure the fitting is not installed in direct line of an air vent/system.
- When installing a fitting in an area prone to moisture, ensure that area is well ventilated and an appropriately
rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product fault, and as
such is not covered under warranty.
• Take care not to pull any electrical wires during unpacking as this may damage the connection.
• Lay out all the components on a smooth surface and make sure there are no components missing before
assembling. If parts are missing, return the complete product to the place of purchase for inspection or
replacement.
• Check whether the fitting has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
• Ensure power to the circuit you are working on has been switched OFF before commencing any electrical work.
Installation directions
1. Remove all packaging material from the product and be careful not to throw away accessories that may be hidden
within the packaging material. To help with assembly, lay the fitting on its side on a smooth non scratch surface.
2. Remove the mounting bracket (C) from the canopy (E).
3. Use the mounting bracket (C) as a template to mark the position of the holes onto the ceiling.
4. Drill holes into the ceiling and put the plastic anchors (A) into the hole. Secure the mounting bracket (C) onto the
ceiling by screws (B) provided. Ensure the screws used are suitable for the mounting surface.
5. Connect the mains supply wire to the light fitting using the terminal block (D) provided. Ensure that the wires are
secure and no bare wires are exposed.
Mains Supply Wire Fitting Wire
Earth – Yellow/Green Yellow/Green or
Neutral – Blue or Black Blue
Live – Brown or Red Brown