Installation instructions

ManualsBrandsLucasey ManualsTVs & monitorsLC2X2WT

Monitor Attaching Screws

Flat Washers

LC2X2WT Front

This end up.

Socket Head Screws

Mountng Slots

Pivot Screws

TIlt Adjusting Screws

Protected under one or more of these U.S. Patent numbers: 3,291,432 3,559,942 3,724,798 DES.270,689 4,613,109 4,878,645 4,852,842 DES.309,5624,973,023 5,169,114 5,255,884 5,310,152 5,522,576 5,621,614 Re.35,677

DES.398,834 5,826,384 5,941,492 5,964,068 6,060,661 6,102,398 6,158,704 6,454,116B1 6,761,276B2 6,806,425B1

Page 5 of 6

LC2X2WT INSTALLATION INSTRUCTIONS

Screw four of the provided Socket Head Screws into the threaded

inserts closest to the monitor on the LC2X2WT Front. Leave 1/2"

of thread exposed.

With two people, lift the monitor, with attached LC2X2WT Front,

onto the LC2X2WT Back making sure that the Socket Head Screws

are engaging the Mounting Slots.

Using a long extension and the appropriate security socket tool

or socket head driver, insert the Tilt Adjusting Screws and Pivot

Screws into the threaded inserts farthest from the monitor.

Remove the Socket Head Screws, only after making sure the Tilt

Adjusting Screws and Pivot Screws are installed. Adjust the tilt

to the desired viewing angle and tighten all four screws.

Note: Security Screws and Socket Head Screws are provided for

convenience. Either can be used to safely install the mount.

Attaching Front Plate to Back Plate

Determine which type of monitor attaching hardware is required

for the monitor as specified by the monitor manufacturer. Various

sizes of monitor attaching screws are provided for convenience.

Make sure the top of the LC2X2WT Front is oriented in the same

direction as the top of the monitor. The holes on the side of the

LC2X2WT Front Plate are closer to the bottom edge than the top edge.

Align the LC2X2WT front plate with the VESA mount pattern on the

back of the monitor. Attach the LC2X2WT Front Plate to the back of

the monitor using the appropriate size screws and washers.

Make sure all of the Monitor Attaching Screws are tight before

proceeding with the rest of the installation.

Monitor Attachment to Front Plate