Installation instructions

LC2X2WT Back
Electrical and/or A/V
wiring plug box cutout
#14 X 2-1/2" Lag Screws
This end up.
Protected under one or more of these U.S. Patent numbers: 3,291,432 3,559,942 3,724,798 DES.270,689 4,613,109 4,878,645 4,852,842 DES.309,5624,973,023 5,169,114 5,255,884 5,310,152 5,522,576 5,621,614 Re.35,677 DES.398,834 5,826,384 5,941,492 5,964,068 6,060,661 6,102,398 6,158,704 6,454,116B1 6,761,276B2 6,806,425B1
Page 4 of 6
LC2X2WT INSTALLATION INSTRUCTIONS
LC2X2WT (8/09) ©2009 Lucasey Manufacturing Corporation, Oakland, California www.lucasey.com
Determine the best possible viewing location for your
monitor taking into account the tilt angle to be used.
Locate a stud using a stud finder in the location
where the monitor is to be mounted.
Follow the instructions that come with the toggle bolt
kit to install the toggle bolt plastic retainers at
each of the three mounting hole locations.
Use the Screws provided with the toggle bolt kit
to attach the LC2X2WT Back to the wall.
(Using optional WMATB3 Toggle Bolt Kit)
Metal Stud Installation
Determine the best possible viewing location for your
monitor taking into account the tilt angle to be used.
Locate a wood stud using a stud finder in the location
where the monitor is to be mounted.
Note: The LC2X2WT can be mounted on the stud with
the mount centered or offset to the left or right 4".
(Optional Toggle Bolts are required for offset
installations or metal stud installations)
Use the LC2X2WT Back Plate as a template to mark
the locations for three pilot holes in the wood studs.
Drill 1/8" pilot holes in the three marked locations.
Use the provided #14 x 2-1/2" Lag Screws to attach
the LC2X2WT Back Plate to the wall.
Wood Stud Installation