SDS

Section 16. Other information
10/6/2017
History
Date of printing
Date of issue/Date of
revision
Version
It is recommended that each customer or recipient of this Safety Data Sheet (SDS study it carefully and consult
resources, as necessary or appropriate, to become aware of and understand the data contained in this SDS and
any hazards associated with the product. This information is provided in good faith and believed to be accurate
as of the effective date herein. However, no warranty, express or implied, is given. The information presented
here applies only to the product as shipped. The addition of any material can change the composition, hazards
and risks of the product. Regulatory requirements are subject to change and may differ between various
locations and jurisdictions. The customer/buyer/user is responsible to ensure that his activities comply with all
country, federal, state, provincial or local laws. The conditions for use of the product are not under the control of
the manufacturer; the customer/buyer/user is responsible to determine the conditions necessary for the safe use
of this product. The customer/buyer/user should not use the product for any purpose other than the purpose
shown in the applicable section of this SDS without first referring to the supplier and obtaining written handling
instructions. Due to the proliferation of sources for information such as manufacturer-specific SDS, the
manufacturer cannot be responsible for SDSs obtained from any other source.
Notice to reader
Date of previous issue
:
:
:
:
Key to abbreviations
:
ATE = Acute Toxicity Estimate
BCF = Bioconcentration Factor
GHS = Globally Harmonized System of Classification and Labelling of Chemicals
IATA = International Air Transport Association
IBC = Intermediate Bulk Container
IMDG = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL = International Convention for the Prevention of Pollution From Ships, 1973
as modified by the Protocol of 1978. ("Marpol" = marine pollution)
UN = United Nations
10/6/2017
No previous validation
1
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4
representing significant hazards or risks. Although HMIS® ratings and the associated label are not required on
SDSs or products leaving a facility under 29 CFR 1910.1200, the preparer may choose to provide them. HMIS®
ratings are to be used with a fully implemented HMIS® program. HMIS® is a registered trademark and service
mark of the American Coatings Association, Inc.
FLAMMABLE AEROSOLS - Category 1
On basis of test data
GASES UNDER PRESSURE - Compressed gas
Calculation method
SKIN CORROSION/IRRITATION - Category 2
Calculation method
SERIOUS EYE DAMAGE/ EYE IRRITATION - Category 2A
Calculation method
TOXIC TO REPRODUCTION (Fertility) - Category 2
Calculation method
SPECIFIC TARGET ORGAN TOXICITY (SINGLE EXPOSURE) (Respiratory tract
irritation) - Category 3
Calculation method
SPECIFIC TARGET ORGAN TOXICITY (SINGLE EXPOSURE) (Narcotic effects) -
Category 3
Calculation method
SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) (lungs) - Category
1
Calculation method
ASPIRATION HAZARD - Category 1
Calculation method
Procedure used to derive the classification
Classification
Justification
Date of issue/Date of revision
:
10/6/2017
Date of previous issue
:
No previous validation
Version
:
1
15/16