SDS

ManualsBrandsLucas Oil ManualsAutomotiveHigh Mileage Oil Stabilizer - 32 oz

Lucas High Mileage Oil Stabilizer

Section 15. Regulatory information

Australia inventory (AICS)

: All components are listed or exempted.

China inventory (IECSC)

: All components are listed or exempted.

Japan inventory

: Not determined.

Korea inventory

: All components are listed or exempted.

Malaysia Inventory (EHS Register)

: Not determined.

New Zealand Inventory of Chemicals (NZIoC)

: All components are listed or exempted.

Philippines inventory (PICCS)

: All components are listed or exempted.

Taiwan inventory (CSNN)

: Not determined.

International lists

Chemical Weapons

Convention List Schedule I

Chemicals

Not listed

Chemical Weapons

Convention List Schedule

II Chemicals

Not listed

Chemical Weapons

Convention List Schedule

III Chemicals

Not listed

Section 16. Other information

History

Prepared by

Key to abbreviations

ATE = Acute Toxicity Estimate

BCF = Bioconcentration Factor

GHS = Globally Harmonized System of Classification and Labelling of Chemicals

IATA = International Air Transport Association

IBC = Intermediate Bulk Container

IMDG = International Maritime Dangerous Goods

LogPow = logarithm of the octanol/water partition coefficient

MARPOL 73/78 = International Convention for the Prevention of Pollution From Ships,

1973 as modified by the Protocol of 1978. ("Marpol" = marine pollution)

UN = United Nations

Hazardous Material Information System (U.S.A.)

National Fire Protection Association (U.S.A.)

Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards

or risks Although HMIS® ratings are not required on SDSs under 29 CFR 1910.1200, the preparer may choose to provide them. HMIS® ratings

are to be used with a fully implemented HMIS® program. HMIS® is a registered mark of the National Paint & Coatings Association (NPCA).

HMIS® materials may be purchased exclusively from J. J. Keller (800) 327-6868.

The customer is responsible for determining the PPE code for this material.

National Fire Protection Association, Quincy, MA 02269. This reprinted material is not the complete and official position of the National Fire

Protection Association, on the referenced subject which is represented only by the standard in its entirety.

by properly trained individuals to identify fire, health and reactivity hazards of chemicals. The user is referred to certain limited number of

chemicals with recommended classifications in NFPA 49 and NFPA 325, which would be used as a guideline only. Whether the chemicals are

classified by NFPA or not, anyone using the 704 systems to classify chemicals does so at their own risk.

Date of issue mm/dd/yyyy

Version

11/04/2016

KMK Regulatory Services Inc.

Notice to reader

To the best of our knowledge, the information contained herein is accurate. However, neither the above-named supplier, nor any of its

subsidiaries, assumes any liability whatsoever for the accuracy or completeness of the information contained herein.

Final determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should

be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist.

Health :

Flammability :

Physical hazards :

Health :

Instability :

Flammability :

Revised Section(s)

Not applicable.

9/9

Tel : +1-888-GHS-7769 (447-7769) / +1-450-GHS-7767 (447-7767)