SDS
Tel : +1-888-GHS-7769 (447-7769) / +1-450-GHS-7767 (447-7767)
www.kmkregservices.com www.askdrluc.com www.ghssmart.com
4
Lucas
Hydraulic
Oil Booster & Stop
L
eak
Section
7.
Handling
and
storage
Precautions
for safe
handling
Protective measures
Advice on
g
eneral
occupational
h
y
giene
Conditions
for safe
sto
rage,
including
an
y
incomp
atibilit
ies
: Put on appropriate personal protective equipment (see Section 8).
: Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. See also Section 8 for additional information on hygiene
measures.
: Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Keep container tightly closed and sealed until
ready for use. Containers that have been opened must be carefully resealed and kept
upright to prevent leakage. Do not store in unlabeled containers. Use appropriate
containment to avoid environmental contamination.
Section
8.
Exposure controls/personal
p
rotection
Control
parameters
Occupational
exposure
limits
Ingredient name
Exposure
limits
Distillates (petroleum), solvent-refined heavy naphthenic
ACGIH TLV (United States, 3/2012).
TWA: 5 mg/m³ 8 hours. Form: Inhalable fraction
NIOSH REL (United States, 6/2009).
TWA: 5 mg/m³ 10 hours. Form: Mist
STEL: 10 mg/m³ 15 minutes. Form: Mist
OSHA PEL (United States, 6/2010).
TWA: 5 mg/m³ 8 hours.
Appropriate engineering
cont
rols
Environmental
exposu
re
cont
rols
: No special ventilation requirements. Good general ventilation should be sufficient to
control worker exposure to airborne contaminants. If this product contains ingredients
with exposure limits, use process enclosures, local exhaust ventilation or other
engineering controls to keep worker exposure below any recommended or statutory
limits.
: Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation.
Individual protection measures
Hygiene measures
:
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period. Ensure
that eyewash stations and safety showers are close to the workstation location.
Eye/face
protectio
n
Skin
protect
ion
Hand
p
rotectio
n
Body
protectio
n
: Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: safety glasses with side-
shields.
: Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary.
: Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist
before
handling
this product.