User Manual

3
www.ltech-led.com
Triac/ELV
Push DIM
LM-150-24-G1T2
LM-150-12-G1T2
Tension plate Remove the protective housing
1. Pry up the protecting housing
in the side plate position with a
tool.
Pull the housing left and right from the bottom to remove it.
2. Connect to electrical wires
with a screwdriver as wiring
diagram shows.
Protective Housing Application Diagram
3. Press down the tension plate to
fix the the electrical wires, then
close the protective housing.
LM-150-24-G1T2
85
87
89
91
93
95
50 60 70 80 90 100
AC230V/50Hz
50 60 70 80 90 100
0.85
0.88
0.91
0.94
0.97
AC230V/50Hz
1.00
50 60 70 80 90 100
0
2
4
6
8
10
THD【%】
AC230V/50Hz
IO【A】
V0【V】
6.25 6.4 6.55 6.7 6.85 7
0
5
10
15
20
25
AC230V/50Hz
Relationship Diagrams
PF
Efficiency【%】
Efficiency vs Load
Power Factor Characteristic
Load【%】 Load【%】
Over Load Diagram
THD vs Load
Load【 %】
Installation Precautions
≥15cm
≥15cm
≥15cm ≥15cm
Please do not stack the products. The distance between two products should be ≥15cm so as not
to affect heat dissipation and the lifespan of the products.
≥15cm
Please not place the products on LED drivers. The distance between the product and the driver
should be ≥15cm so as not to affect heat dissipation and shorten the lifespan of the products.