Owner manual

41
4/8/16CH Triplex DVR
Digital Video Recorder
5.4.1.
sor mode as “Not Installed”, “Normal-Open” or “Normal-Close”.
To set the sensor’s record time as 5sec, 10sec, 15sec, 20sec, 25sec,
sec, 90
sec, 120sec, 150sec or 180sec.
de
Sensor Mode
Set the sen
5.4.2. Record Time
30sec, 45sec
, 60
5.4.3. Alarm Mo
To set the motion detector alarm mode.
“Mute”: No beep whatever detecting.
“
Buzzer-Short”: Beep shortly by buzzer on main board when
detection is active
“
Buzzer-Long”: Beep long by buzzer on main board when detection
is active
“
Alarm-Short”: Beep shortly by speaker of system when detection is
active
Alarm-Long”: Be“ ep long by speaker of system when detection is
To Setup the time period of beep by “Nonstop”(no stop), 5sec, 10sec,
15sec, 20sec
, 25sec, 30sec, 35sec, 40sec, 45sec, 50sec, 55sec or 60sec
5.4.5. Trigger Full Screen
Display the trigger channel on full screen when it act as 1, 2sec … 30sec.
active
5.4.4. Alarm Time
“
OFF”: It will not display on full screen when the channel has been
triggered.
ype
There are two trigger types: “Initial Trigger” and “Continuous Trigger” for
selection.
Initial Trigger: When channel has been triggered, it will display on full
screen as the setting time period. In that time period, this channel will
ignore any other trigger.
Continuous Trigger: When channel has been triggered, it will display on
full screen as the setting time period. In that time period, this channel is
still watching out. If anot r r ger act, the channel will display on full
all over again by the setting time period.
5.4.6. Trigger T
he t ig
screen and count