Owner manual

INSTRUCTION MANUAL

4. DVR INSTALLATION GUIDELINE

4.1 FRONT PANEL

1. THE DEFINITION OF BOTTOMS AND CONNECTORS ON FRONT PANEL

1） Power: Press to power the system ON/OFF.

2） IR Sensor: IR receiver for the remote control.

3） LED Indicators: Shows status of HDD, recording, alarm, network, and power.

4） Channel/Numbers/Playback: Press buttons 1~4 (4-channel models) or 1~8

(8-channel models) to view the selected channel in full-screen; press buttons 1~0 to input

passwords and user IDs; during playback, press the following:

• 6/ : Increase reverse playback speed 1X, 2X, 4X

• 7/ : Press to freeze playback to one frame, then press again to advance

frame-by-frame

• 8/ : Press to start playback

• 9/ : Press to slow playback speed by 1/2, 1/4, 1/8

• 0/ : Press to increase forward playback speed 1X, 2X, 4X

5） MENU/EXIT: Press to open/close the main menu.

6） Navigation/OK: Press the Navigation buttons to perform the following:

• OK: In menus, press to confirm selections; in PTZ mode, press to change the

navigation buttons to control the connected PTZ camera (not included)

• : Press to move cursor up; in PTZ mode, press to pan camera up

• : Press to move cursor down; in PTZ mode, press to pan camera down

• : Press to move cursor left; in PTZ mode, press to pan camera left

• : Press to move cursor right; in PTZ mode, press to pan camera right

7） USB: Connect a USB flash drive to the top port for data backup and firmware

upgrades connect a USB mouse to the bottom port.