Owner manual

INSTRUCTION MANUAL

18 NETWORK

Use the Network Setup menu to configure your network and DNS settings.

Figure 2.4.2.18.1 network setup

UPNP

UPnP Forum is an industry initiative designed to enable simple and robust connectivity

among consumer electronics, intelligent appliances and mobile devices from many

different vendors. As a group, we are dedicated to making the connected home and

lifestyle mainstream experiences for consumers - and great opportunities for the industry.

NOTE: Need your Router to support UPNP function.

To configure UPNP settings:

1） Enable the UPNP function in your Router.

2） Under DVR GUI，Open the MAIN MENU and click ADVANCE.

3） From the Advanced Setup menu, click NETWORK.

4） Under UPNP, select OPEN.

5） Click APPLY to save your settings and then click OK in the confirmation window.

6） Using a remote PC, open Internet Explorer.

7） In the address bar, enter your Router WAN IP address immediately followed

by :WEB PORT (no spaces).

http://XXX.XXX.XXX.XXX(Router WAN IP):XXX(WEB PORT)

8) Enter your system ADMIN password and select INTERNET.

NOTE: If you have not enabled passwords on the system, leave the password field blank.

9) Click LOGIN.

To configure network settings:

1） Under TYPE, select DHCP, PPPoE, or STATIC. If DHCP, go to step 5. If PPPoE,

go to step 2. If STATIC, go to step 3.

NOTE: DHCP allows you to quickly connect to your network by obtaining an IP

address from the router. After the initial setup, we recommend that you disable DHCP and

set the IP address between 1~100. For example, if your IP address is 192.168.0.107,

change the last digits to 90 (i.e. 192.163.0.90). This ensures that port forwarding will not

change in the event of power failure or resetting of your network.

2） If you select PPPoE in step 1, enter your PPPoE user name and password in the

respective fields using the Virtual Keyboard.