User Manual

Digital Video Recorder User Manual version 1.0
16
Fig 4-11 record configuration-enable
Step2: tick off record, audio and record time
Step3: user can setup all channels with same parameters, tick off “all”, then to do relevant setup.
Step4: click “default” button to resort default setting; click “apply” button to save the setting; click “exit” button to exit current interface.
Definitions and descriptions of Record:
Parameter
Meaning
Record Record switch of every channels
Audio Enable live record audio
4.3.2 Record stream
Step1: enter into system configurationrecord configurationrecord bit rate; refer to Fig 4-12:
Fig 4-12 record configuration-record bit rate
Step2: setup rate, resolution, quality, encode and max bit stream
Step3: user can setup all channels with same parameters, tick off “All”, then to do relevant setup.
Step4: click “default” button to resort default setting; click “apply” button to save the setting; click “exit” button to exit current interface.
Note: if the rate value set is over high the maximum resources of the device, the value will be adjusted automatically.
Definitions and descriptions of Record stream:
Parameter Meaning
Rate
Range from: 1-30（NTSC）1-25(PAL)
Resolution Support CIF and D1
Quality The quality of recorded images. The higher the value is, the clearer the recorded image
is. Six
option
s
: lowest, lower, low, medium, higher and highest.
Encode VBR and CBR
Max bit stream
Range from: 64 Kbps、128 Kbps、256 Kbps、512 Kbps、768 Kbps、1Mbps、2 Mbps
4.3.3 Time
Step1: enter into system configurationrecord configuration time; refer to Fig 4-13: