User guide

LSI Corporation
- 24 -
Syncro CS 9286-8e Solution User Guide
March 2013
Chapter 3: Creating the Syncro CS 9286-8e Configuration
Creating Virtual Drives on the Controller Nodes
3. Right-click on the Command Prompt. A properties check indicator appears on the button, as shown in the
following figure.
Figure 16 Command Prompt
The following button appears at the bottom of the desktop to open the command prompt as Administrator.
Figure 17 Run as Administrator Button
4. Click the button to open a command prompt, as shown in the following figure.
Figure 18 Windows Command Prompt
5. Enter the following command at the prompt:
megacli64 –cfgdsply –a0
The -a0 parameter presumes that there is only one Syncro CS 9286-8e controller in the system or that these steps
reference the first Syncro CS 9286-8e controller in a system with multiple controllers.


