Logic Symbios SYM20810 PCI to SCSI Host Adapter

1-14 What is Covered in this Guide
1.4 Troubleshooting
During installation, no SCSI devices are found:
• Check the cable connections and the host bus adapter installation.
• Ensure that all devices are powered on and terminated correctly.
• Check that no devices have duplicate SCSI IDs.
• Make sure INT A is assigned for the PCI slot(s) where your SCSI
host adapter(s) are installed.
• Make sure the SCSI device driver is installed properly.
The computer hangs or locks up when booting and the SCSI devices
attached are not seen by the computer system:
• Make sure that all the SCSI devices are configured at different ID
numbers (the boot drive should have the lowest ID).
• Make sure both ends, but only the ends, of the SCSI bus are
terminated.
• (DOS, OS/2) Make sure the device driver is listed in CONFIG.SYS
(and loaded when booting).
The device driver does not see one of the SCSI devices:
• Reboot the computer.
• Make sure the SCSI devices have different ID numbers (the boot
drive should have the lowest ID).
• Make sure both ends, but only the ends, of the SCSI bus are
terminated.
• Check the cable and power connections.