Logic MegaRAID SCSI 320-1 RAID Controller User's Guide

Installation Steps 6-17

The <Ctrl><M> utility prompt times out after several seconds. The

MegaRAID SCSI 320-1 host adapter (controller) number, firmware

version, and cache DRAM size are displayed in the second portion of the

BIOS message. The numbering of the controllers follows the PCI slot

scanning order used by the host motherboard.

6.2.9 Step 9: Run the MegaRAID BIOS Configuration Utility

Press <Ctrl><M> to run the MegaRAID BIOS Configuration Utility. See

the MegaRAID Configuration Software Guide for information about

running this utility.

6.2.10 Step 10: Install the Operating System Driver

MegaRAID can operate under MS-DOS or any DOS-compatible

operating system using the standard AT BIOS INT 13h Hard Disk Drive

interface. To operate with other operating systems, you must install

software drivers. MegaRAID provides software drivers on the Driver and

Documentation CD for the following operating systems:

· MS-DOS version 6.xx or later

· Microsoft Windows NT 4.0, Windows 2000, Windows XP, Windows

.NET

· Novell NetWare 5.1, 6.0

· Red Hat Linux 7.2, 7.3

Note:

Refer to the MegaRAID Driver Installation Guide for the

procedures used to install operating system drivers.