Logic MegaRAID SCSI 320-1 RAID Controller User's Guide

6-16 Hardware Installation
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
6.2.7.2 Target IDs as Presented to the Operating System
Table 6.7 shows the target IDs as presented to the operating system.
6.2.8 Step 8: Power Up
Replace the computer cover and reconnect the AC power cords. Turn
power on to the host computer. Set up the power supplies so that the
SCSI devices are powered up at the same time as or before the host
computer. If the computer is powered up before a SCSI device, the
device might not be recognized.
During boot, the MegaRAID SCSI 320-1 BIOS message appears:
MegaRAID SCSI 320-1 Disk Array Adapter BIOS Version x.xx
date
Copyright (c) LSI Logic Corporation
Firmware Initializing... [ Scanning SCSI Device ..(etc.).. ]
The firmware takes several seconds to initialize. During this time the
adapter will scan the SCSI channel(s). When ready, the following
appears:
Host Adapter-1 Firmware Version x.xx DRAM Size 16 MB
0 Logical Drives found on the Host Adapter
0 Logical Drives handled by BIOS
Press <Ctrl><M> to run MegaRAID SCSI 320-1 BIOS
Configuration Utility
Table 6.7 Target IDs as Presented to the Operating System
ID LUN Device ID LUN Device
00Disk (A1-X)10
01Disk (A2-X) 20CD
02Disk (A3-X) 30Tape
03Disk (A4-X)40CD
04Disk (A5-X)50Tape
05Disk (A6-X)60
06Disk (A7-X)
07Disk (A8-X)