Logic MegaRAID SCSI 320-1 RAID Controller User's Guide

Installation Steps 6-13
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Figure 6.7 Installing the MegaRAID SCSI 320-1 Controller
6.2.6 Step 6: Connect SCSI Devices
Use SCSI cables to connectSCSI devices to the MegaRAID SCSI 320-1.
The MegaRAID SCSI 320-1 provides two SCSI connectors:
· J1, the internal high-density 68-pin SCSI connector for Wide (16-bit)
SCSI
· J7, the external very high-density 68-pin SCSI connector
Use this procedure to connect SCSI devices:
1. Disable termination on any SCSI device that does not sit at the end
of the SCSI bus.
32-bit Slots
64-bit Slots
(3.3 V)
(5 V)
Bracket Screw