User`s guide

MegaRAID SAS Device Driver Installation User’s Guide 2-1

Chapter 2

Windows Driver

Installation

This chapter describes the installation of the following Windows

operating systems:

• Windows 2000

• Windows XP

• Windows XP x64

• Windows Server 2003 (x86)

• Windows Server 2003 (x64)

• Windows Vista

This chapter consists of the following sections:

• Section 2.1, “Installing the Windows System Driver in a New

Windows System”

• Section 2.2, “Installing or Updating the MegaRAID Driver in an

Existing Windows System”

Note

: When you connect an Engenio

Shea JBOD to a SAS

RAID controller and boot up the system to a Windows

operating system, a message displays asking for a driver

for the Shea JBOD. You need to install the SES processor

in the Shea JBOD by pointing to the same location where

the MegaRAID

driver package is located, the file

Nodev.inf. The Nodev.inf file (in the driver package) has

the entries required to install the processor correctly. This

file supports the following enclosure IDs:

EnclosureLSILOGIC_____SYM3600-SAS and

EnclosureIBM-ESXSEXP3000_________.