Installation guide

Chapter 2. CLI Syntax Reference
78 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2
Unit UnitType Status %RCmpl %V/I/M VPort Stripe Size(GB)
------------------------------------------------------------------------
u1 RAID-0 OK - - - 64K 3576.06
u1-0 DISK OK - - p0 - 298.01
u1-1 DISK OK - - p1 - 298.01
u1-2 DISK OK - - p2 - 298.01
u1-3 DISK OK - - p3 - 298.01
u1-4 DISK OK - - p4 - 298.01
u1-5 DISK OK - - p5 - 298.01
u1-6 DISK OK - - p6 - 298.01
u1-7 DISK OK - - p7 - 298.01
u1-8 DISK OK - - p8 - 298.01
u1-9 DISK OK - - p9 - 298.01
u1-10 DISK OK - - p10 - 298.01
u1-11 DISK OK - - p11 - 298.01
u1/v0 Volume - - - - - 2047.00
u1/v1 Volume - - - - - 1529.06
/cx/ux remove [noscan] [quiet]
The /cx/ux remove command allows you to remove a unit. Removing a unit
instructs the firmware to remove the specified unit from its list of managed
units, but retains the Disk Configuration Block (DCB) metadata. A logically
removed unit can be physically moved to a different controller or reinstalled
at a later time.
noscan is used to prevent informing the operating system of this change. The
default is to inform the operating system.
quiet is used for noninteractive mode. Confirmation statements are
suppressed and the command is executed immediately. Using the quiet mode
is useful for scripting purposes.
Example of interactive mode:
//localhost> /c0/u0 remove
Removing /c0/u0 will take the unit offline.
Do you want to continue?
Y|N [N]:
Note: After the unit is removed through the CLI, the unit can be physically
removed. You can physically remove hot-swap bays while the system is online.