Installation guide

Unit Object Commands
www.lsi.com/channel/products 77
/cx/ux show storsave
The /cx/ux show storsave command shows the storsave policy on the unit.
For more information see, “/cx/ux set storsave=protect|balance|perform
[quiet]” on page 84.
Example:
//localhost> /c0/u5 show storsave
/c0/u5 Command Storsave Policy = protect
/cx/ux show verifystatus
The /cx/ux show verifystatus command shows the verifystatus (if any) of the
specified unit.
Example:
//localhost> /c0/u5 show verifystatus
/c0/u5 is not verifying, its current state is OK
/cx/ux show volumes
The /cx/ux show volumes command shows the number of volumes in the
specified unit. Normally there is one volume unless autocarving is enabled
and/or a boot volume was specified.
Example:
//localhost> /c0/u0 show volumes
/c0/u0 volume(s) = 1
/cx/ux show all
The /cx/ux show all command shows the current setting of all unit attributes.
Example:
//localhost> /c0/u1 show all
/c0/u1 status = OK
/c0/u1 is not rebuilding, its current state is OK
/c0/u1 is not verifying, its current state is OK
/c0/u1 is not initializing, its current state is OK
/c0/u1 Write Cache = on
/c0/u1 Read Cache = Intelligent
/c0/u1 volume(s) = 2
/c0/u1 name = myarray
/c0/u1 serial number = C6CPR7JMF98DA8001DF0
/c0/u1 Ignore ECC policy = on
/c0/u1 Auto Verify Policy = on
/co/u1 Storsave policy = protection
/c0/u1 Command Queuing Policy = on
/c0/u1 Rapid RAID Recovery setting = all