Installation guide

Controller Object Commands

www.lsi.com/channel/products 61

2 Use the /cx del verify command to remove any of the scheduled tasks

which do not match your desired schedule.

3 Use the /cx add verify command to create the verify schedule slots you

want (described above.)

4Use the /cx set verify=enable command or the /cx set verify=advanced

to enable the schedule (this enables all rebuild schedule slots).

5Use the /cx/ux set autoverify=on command to turn on autoverify for each

unit you want to follow the schedule.

add selftest=ddd:hh

The /cx add selftest command adds a new task slot to the Selftest Task

Schedule on the day ddd (where ddd is Sun, Mon, Tue, Wed, Thu, Fri, and

Sat), at hour hh (range 0 .. 23). Notice that selftest runs to completion and, as

such, no duration is provided. A maximum of seven selftest task slots can be

included in the schedule. This command fails if an (empty) task slot is not

available.

In order to run at the specified times, selftests must be enabled, using the

command “/cx set selftest=enable|disable” on page 68.

Note: Adding selftests to the schedule is different from adding slots to the

rebuild and verify schedules. Adding a selftest directly schedules the test and

defines a time slot during which the task can occur.

Example:

//localhost> /c1 add selftest=Sun:16

Adding scheduled verify to slot 7 for [Sun, 4:00PM] ... Done.

In this example, a selftest background task is scheduled to run on Sundays at

16 hours (4:00 PM).

Setting Up a Selftest Schedule

Setting up a selftest schedule requires several steps, and several different CLI

commands in addition to /cx add selftest.

To set up the selftest schedule, follow this process:

1 Use the /cx show selftest command to show the current schedule for

selftest tasks.

Note: If you do not enable autoverify for units or start a verification manually,

verifies will not run during your verify task schedule even if you use the /cx set

verify=basic command, the /cx set verify=advanced command, or the /cx set

verify=enabled command to enable the verify schedule.