Installation guide

Chapter 2. CLI Syntax Reference
26 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2
• /c0/bbu specifies a relative path with respect to the current focused
hostname.
Example:
//localhost> focus /c0/u0
//localhost/c0/u0>
//localhost/c0/u0> focus..
//localhost/c0>
//localhost> focus u0
//localhost/c0/u0>
//localhost/c0> focus /
//localhost>
commit
The commit command sends a commit command to all 3ware controllers in
the system. For more information, see “/cx commit” on page 58.
flush
The flush command sends a flush command to all 3ware controllers in the
system. For more information, see “/cx flush” on page 58.
rescan
The rescan command sends a rescan command to all 3ware controllers in the
system. For more information, see “/cx rescan [noscan]” on page 57.
show
The show command shows a general summary of all detected controllers and
enclosures.
The output of this command can vary depending upon your controller model
and whether the system has an enclosure with an expander attached.
Note that the device drivers for the appropriate operating system must be
loaded for the list to show all controllers.