Installation guide

Enclosure Object and Element Commands
www.lsi.com/channel/products 113
2 - Low
3 - Medium-low
4 - Medium
5 - Medium-high
6 - High
7 - Highest
The Identify column lists the Identify setting of the fans.
Example:
//localhost> /c0/e0 show fans
---Speed---
Fan Status State Step RPM Identify
------------------------------------------------------------
fan0 OK ON 1 2670 Off
fan1 OK ON 1 9370 Off
fan2 OK ON 1 8540 Off
fan3 OK ON 1 2810 Off
fan4 OK ON 1 9240 Off
fan5 OK ON 1 8330 Off
/cx/ex show temp
The /cx/ex show temp command applies only to 9750 and 9690SA
controllers. For the 9650SE, simply drop the prepended controller name in the
command and use /ex.
The /cx/ex show temp command lists the temperature sensors in enclosure
/cx/ex and the current temperature.
The maximum temperature for successful use of a drive should be noted in the
documentation for the drive.
The TempSensor column lists the temperature sensor IDs, the Status column
lists the status of each temperature sensor, the Temperature column lists the
temperature at the sensors, and the Identify column lists the Identify setting of
the temperature sensors
Example:
//localhost> /c0/e0 show temp
TempSensor Status Temperature Identify
--------------------------------------------------------
temp0 OK 41C(105F) Off
temp1 OK 37C(98F) Off
temp2 OK 34C(93F) Off
temp3 OK 38C(100F) Off
temp4 OK 38C(100F) Off
temp5 OK 34C(93F) Off
temp6 NOT-INSTALLED - Off
temp7 NOT-INSTALLED - Off