Installation guide

Chapter 2. CLI Syntax Reference
112 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2
/cx/ex/ show diag=helptext
The /cx/ex show diag=helptext command applies only to 9750 and 9690SA
controllers. For the 9650SE, simply drop the prepended controller name in the
command and use /ex.
The /cx/ex show diag=helptext command allows you to view the enclosure
diagnostic log. What is reported by this log varies depending upon the
manufacturer of the enclosure. The enclosure diagnostic log might be
requested by 3ware Customer Support to help troubleshoot problems on your
enclosure.
/cx/ex show slots
The /cx/ex show slots command applies only to 9750 and 9690SA controllers.
For the 9650SE and CCU enclosure, simply drop the prepended controller
name in the command and use /ex.
The /cx/ex show slots command shows the slots in enclosure /cx/ex and their
associated information. The Slot column lists the slot IDs, the Status column
lists the status of each slot, the (V)Port column shows the associated port or
virtual port of each slot, and the Identify column lists the Identify setting of
the slots
Example:
//localhost> /c0/e0 show slots
Slot Status (V)Port Identify
----------------------------------------------------
slot0 OK /c0/p0 No
slot1 OK /c0/p1 Yes
slot2 NO-DEVICE - No
slot3 NO-DEVICE - No
/cx/ex show fans
The /cx/ex show fans command applies only to 9750 and 9690SA controllers.
For the 9650SE, simply drop the prepended controller name in the command
and use /ex.
The /cx/ex show fans command lists the fans in enclosure /cx/ex and shows
their status, as shown in the example below.
The Status column lists the status of each fan. The State column indicates
whether the fan is On or Off. Speed is shown by two columns. One shows the
Step (level) and the other shows the RPM (revolutions per minute). There are
seven speed levels:
0 - Off
1 - Lowest