User guide
Changing the Phy Link Speed
www.lsi.com/channel/products 89
Changing the Phy Link Speed
You can change the link speed between the controller and an expander or
between the controller and a drive that is directly connected to the controller.
Typically, the phy link speed is set to Auto. If desired for compatibility,
troubleshooting or performance analysis, you can specify a specific link speed
(1.5, 3.0, or 6.0 Gbps).
To change the phy link speed in 3DM 2
1 On the Controller Phy Summary page, identify the phy device for which
you wish to change the link speed. Direct-attached drives are identified by
their VPort ID.
2In the
Link Control drop-down menu, select the desired speed: 6 Gbps, 3
Gbps, 1.5 Gbps, or Auto.
The link speed is now reset.
For details about the information displayed on this screen, see “Controller
Phy Summary page” on page 210.
Figure 39. Controller Phy Summary page