| | 3 _Description : Metal Detector with Detachable Handle instruction Manual Features « A hand-held scanner to detect cons, pins, called & other metal objects. A two-piece handle assembly converts the hand-held scanner lo a ground-sweeping metal detector. A red LED to indicate power green LED to indicate metal js detected. A beeps sound to indicate metal is detected. Intelligent memory circuit to switch the scanner to standby manner automatically.
How to use your Metal Detector 1. Take away the screw with screwdriver, and open the battery soot, install 9V battery (6F22 x 1 pe), close the battery door wit with screw. 2. Turn the sensor knob to "ON" position , then hold the scanner and keep the detected zone away from metal object. 3. Continue slowly muting the knob with your thumb unit the green light turns on and yous hear a beeping noise. Now rotate the dia slightly in the opposite direction until the noise stops and the green light tums off. 4.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not Installed and used in accordance with the instructions, may cause harmful Interference to radio communications.
