User Guide

38
To unconfigure an EP-35 temp sensor:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
ENTER.
2. Highlight
BUS DEVICES and press ENTER. The Bus Devices list will
appear, showing all devices detected on the network.
3. Choose the temp sensor you want to unconfigure and press
ENTER.
Select
UNCONFIGURE from the temp configuration menu and press ENTER.
The following message will appear: Press Menu to UnConfig Device
Name.
4. Press
ENTER to unconfigure the sensor and be directed back to the
Bus Devices list where the temp now will be listed as UnCfg Temp.
To reconfigure an EP-35 temp sensor:
To reconfigure a sensor, there must be a configuration name available
(Water, Outside or Inside). If all three temp sensors have been
configured, you first will have to unconfigure a temp sensor to make its
name available for reconfiguration. If you try to reconfigure a sensor
when the desired configuration name (Water, Outside and Inside) is in
use, a Name Already Selected message will appear.
If all three temps are configured, which means there is no name
configuration available, follow the first set of instructions. If the desired
configuration name is available, follow the second set of instructions.
The steps below will show you how to switch the configuration of a
water temp to an outside temp.
If all temps configured (Configuration name unavailable):
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
ENTER.
2. Highlight
BUS DEVICES and press ENTER. Select OUT: T (Outside Temp)
and press
ENTER to open the temp configuration menu.
3. Select
UNCONFIGURE and press ENTER. The following message will pop
up: Press Enter to UnConfig Device Name.
4. Press
ENTER to unconfigure the sensor and be taken back to the Bus
Devices list. The Outside temp is now unconfigured and will be
displayed as UnCfg Temp. Its configuration name (Outside) is now
available, so you will be able to use it to reconfigure the Water temp
sensor.
5. Highlight
WTR: T and press ENTER, which will open the temp
configuration menu. Select
RECONFIGURE and press ENTER. That will
direct you to the Temp Selection menu, which will have three options:
Water, Outside and Inside.