Manual

ManualsBrandsLouroe Electronics ManualsAudio EquipmentOmni-directional Stainless Steel Faceplate Microphone

Table Of Contents

The Verifact Models D and D-V are omni-directional, low impedance,

electret condenser microphones with built-in preamp. They can pick up

normal sounds approximately 15’ away if mounted to a wall, or within a

30’ circle if ceiling mounted. The microphone and pre-amp are mounted

to the back of a single gang stainless face plate. Model D-V is designed

for correctional facilities, or areas where vandalism is a concern. It

contains the identical electronics as the Verifact D Microphone but is

mounted to a 16 gauge stainless steel face plate. Microphone opening

is a hooded audio port for providing protection to the microphone.

Tamper proof screws are included with the D-V.

Both Verifact D and D-V fit into a standard single gang electrical box (not

supplied).

MODEL Verifact

D-V Microphone

Vandal Resistant

MODEL Verifact

D Microphone

D/D-V MIC 1/08

OUROEOUROE

LECTRONICSLECTRONICS

6955 VALJEAN AVE, VAN NUYS, CA 91406

PH: (818)994-6498 / FAX: (818)994-6458

sales@louroe.com / www.louroe.com

MODEL D/D-V

MICROPHONES

INSTALLATION AND OPERATING INSTRUCTIONS

Summary of content (4 pages)

PAGE 1
MODEL D/D-V LOUROE E MICROPHONES LECTRONIC S 6955 VALJEAN AVE, VAN NUYS, CA 91406 PH: (818)994-6498 / FAX: (818)994-6458 sales@louroe.com / www.louroe.com INSTALLATION AND OPERATING INSTRUCTIONS MODEL Verifact D Microphone MODEL Verifact D-V Microphone Vandal Resistant The Verifact Models D and D-V are omni-directional, low impedance, electret condenser microphones with built-in preamp.
PAGE 2
INSTALLATION AND OPERATING INSTRUCTIONS WIRING REQUIREMENTS 2 Conductor shielded cable, 22 gauge with a 24 gauge drain wire NOTE: Unshielded cable is not satisfactory for audio systems MECHANICAL INSTALLATION: Models D and D-V are designed to be installed in a single gang electrical box for flush or surface mounting to a wall or ceiling. It should be positioned 3 to 6 ft. from the area of desired coverage. Ceiling heights in excess of 10 ft. should be avoided.
PAGE 3
INSTALLATION AND OPERATING INSTRUCTIONS INSTALLATION TIP: If area to be monitored for audio is noisy or has background disturbances, the microphone should be positioned close to the subject (2’ - 6’) if possible. CONNECTING MODEL D OR D-V MICROPHONE TO OTHER AUDIO SOURCES If a Louroe audio base station or interface adapter is not used and microphone is to be connected directly to another audio source, use the following procedure: 1. Apply 12 Vdc power (100mA minimum) to PC board’s terminals A and C.
PAGE 4
LOUROE E LECTRONIC S MANUFACTURED IN THE IMPORTANT NOTICE When this equipment is used as part of an audio monitoring system, the law requires that the public be given notice of AUDIO MONITORING ON THE PREMISES. A decal notice is included with each microphone shipped. AUDIO MONITORING On These Premises L OUROE E LECTRONIC S Federal Law References: Federal Regulations, US Code, Title 18. Crime and Criminal Procedure, Sec 2510. SPECIFICATIONS Sensitivity (microphone & preamp) 80 dB SPL input provides 0.