Manual

ManualsBrandsLouroe Electronics ManualsAudio EquipmentTLMC-W Microphone & 4-inch Speaker, Flush or Surface Mount

Table Of Contents

Model TLMC is two-way talk/listen remote call station. It contains a microphone, speaker and call button all within one housing.

As part of a Louroe Sound Activated System, it can activate the Louroe Alarming Base Station (ALA or DG series) by a sound

exceeding the threshold level or by pushing the call button. Once activated, person at the TLMC can communicate

hands-free with the Louroe Base Station. A selector switch on PC board allows a choice of activation by pushbutton only, or a

combination of pushbutton and sound activation. An LED is illuminated on the front panel of TLMC when a call is

acknowledged from the Louroe Base Station.

Two backboxes are included with the TLMC. One (metal) for surface mounting to a wall or flat surface and one (plastic) for

flush mounting.

MODEL TLMC

Flush or SurfaceMount

To Wall

OUROE

LECTRONICS

6955 VALJEAN AVE, VAN NUYS, CA 91406

PH: (818)994-6498 / FAX: (818)994-6458

sales@louroe.com / www.louroe.com

TLMC

REMOTE CALL STATION

INSTALLATION AND OPERATING INSTRUCTIONS

WIRING REQUIREMENTS

4 Conductor consisting of:

2 Conductor shielded, 20 gauge

with 22 gauge drain (microphone

connection)

2 Conductor unshielded, 18 gauge

(speaker connection)

All in the same jacket

Backbox (metal) for surface

mounting to wall or

flat surface

Backbox (plastic) for flush

mounting to wall or

flat surface

TLMC-W-in 6/08

Summary of content (8 pages)

PAGE 1
L OUROE E LECTRONICS 6955 VALJEAN AVE, VAN NUYS, CA 91406 PH: (818)994-6498 / FAX: (818)994-6458 sales@louroe.com / www.louroe.com TLMC REMOTE CALL STATION INSTALLATION AND OPERATING INSTRUCTIONS Backbox (plastic) for flush mounting to wall or flat surface MODEL TLMC Flush or SurfaceMount To Wall Backbox (metal) for surface mounting to wall or flat surface Model TLMC is two-way talk/listen remote call station. It contains a microphone, speaker and call button all within one housing.
PAGE 2
INSTALLATION AND OPERATING INSTRUCTIONS MICROPHONE AND SPEAKER WIRING CONNECTIONS Microphone Portion 1) Connect cable to TLMC as shown in the wiring diagram page 3. 2) Connect microphone wires (2 cond. shielded) to terminal block of PC board marked “A”, “B” and “C”. If using West Penn 356: a. Connect RED wire to terminal marked “A”. b. Connect BLACK wire to terminal marked “B”. c. Connect DRAIN (bare) wire to terminal marked “C”.
PAGE 3
INSTALLATION AND OPERATING INSTRUCTIONS TLMC WIRING DIAGRAM REAR OF TLMC FACE PLATE PC BOARD SPEAKER POSITIVE (SP) SPEAKER RETURN WIRE (7) TIME SELECTOR DIP SWITCH (S4) MIC +12Vdc SUPPLY (A) Audio Output (B) GROUND (C) NORMAL OR TIMED AUDIO SELECTOR SWITCH 1 = 30 seconds of activation 2 = 60 seconds of activation 600 / 70 VOLT SELECTOR SWITCH FACTORY SET AT 70V SPEAKER LEVEL CONTROL Factory set do not adjust unless necessary 4 CONDUCTOR CABLE WEST PENN 356 OR EQUIVALENT Clockwise to Increase Counte
PAGE 4
INSTALLATION AND OPERATING INSTRUCTIONS OPERATIONS AND TEST OF TLMC 1) FOR NORMAL OPERATION (MANUAL RESET) A. The Louroe Base Station can be triggered either by pressing the call button or by generating a loud sound or shouting (when used with Alarming Base Stations DG-12II/25III or ALA-4/8 Series). B. Move slide switch “S2” of TLMC PC Board to position marked “N”. C. Once an alarm is initiated, the operator at the Louroe base station can respond to the TLMC that initiated the call.
PAGE 5
INSTALLATION AND OPERATING INSTRUCTIONS INSTALLATION OF TLMC CALL STATION Model TLMC is designed for mounting to a wall or flat surface. Included are two backboxes: White plastic backbox is for flush mount Beige metal backbox is for surface mount Lift and separate plastic backbox from metal backbox (2) backboxes plastic backbox PLEASE NOTE metal backbox I SURFACE MOUNTING BACKBOX TO WALL a. Metal backbox has 4 mounting holes for securing to wall (screws not supplied). b.
PAGE 6
INSTALLATION AND OPERATING INSTRUCTIONS SPECIFICATIONS (Microphone) Output impedance (mic only) Output Frequency response Current drain Supply voltage 600Ω unbalanced Line Level(0 dB @ 1KΩ ) 40 Hz to 15 kHz ± 1 dB 4 mA 12 Vdc SPECIFICATIONS (Speaker) Power rating Input Frequency response Voice coil impedance Magnet Speaker size 10W 70V constant 300 Hz to 4 kHz 8Ω 3 oz. Ceramic 4" (10cm) SPECIFICATIONS (Mechanical) Dimensions (Face Plate) 8"H x 6¼"W metric (20.3cm H x 15.
PAGE 7
INSTALLATION AND OPERATING INSTRUCTIONS IMPORTANT NOTICE When this equipment is used as part of an audio monitoring system, the law requires that the public be given notice of AUDIO MONITORING ON THE PREMISES. A decal notice is included with each microphone shipped. AUDIO MONITORING On These Premises L OUROE E LECTRONICS Federal Law References: Federal Regulations, US Code, Title 18. Crime and Criminal Procedure, Sec 2510.
PAGE 8
L OUROE E LECTRONICS MANUFACTURED IN THE LOUROE ELECTRONICS 6955 VALJEAN AVENUE, VAN NUYS, CA 91406 USA TEL (818) 994-6498 FAX (818) 994-6458 Website: www.louroe.com Email: sales@louroe.