Installation Guide

8
ALUMINUM MODELS ONLY:
A. Using a tape measure double check the height of the ceiling.
B. Determine the location to cut the ladder rail and ladder feet for your ceiling height. Follow
table 3 and Figure 12.
CEILING HEIGHT
RAIL CUT LOCATION
FOOT CUT LOCATION
7' 8" - 7' 9"
Angle cut at step #3
Line E
7' 10" - 7' 11"
Straight cut at line C
Line E
8' - 8' 3"
Straight cut at line C
Line D
8' 4" - 8' 5"
Straight cut at line C
No cut
8' 6' - 8' 7"
Angle cut at step #2
No cut
8' 8" - 9' 2"
Straight cut at line B
No cut
9' 3" - 9' 4"
Straight cut at line A
No cut
9' 5" - 9' 10"
Angle cut at step #1
No cut
9' 11" - 10' 3"
No cut
No cut
TABLE 3
1
FIGURE 12
2
C. Cut the side rails and ladder feet (when required) at the appropriate line.
3
NOTE: The rail is not pre–marked for angle cuts.
4
5
D. Press down on the climbing section to ensure that the folding arms are fully extended.
6
7