User's Manual

PAU S I N G A SC A N
Pause a scan via:
Codelog > 2)Scan > 1)Continue to Log Data > 0)Pause Scan
The Pause function suspends the scan cycle on the frequency and antenna that is
being scanned. The receiver does not change the frequency or antenna it is
scanning when pause is selected, but it does continue to log data for that
frequency and antenna.
Any settings that are changed while paused are applied only to the frequency
and antenna that the receiver was scanning when pause was selected.
VI E W I N G T H E DI S P L AY SC R O L L
As valid detections are made, they are recorded by the receiver and made
available for viewing. Up to 64 valid detections can be accumulated for viewing
during a scan. After 64 initial valid detections have been made, the receiver starts
replacing the oldest detection with the most recent (this affects viewing only).
The receiver does not stop collecting data while using this feature.
Access the display scroll via:
Codelog > 2)Scan > 1)Continue to log data > 2)View > 1)Display Scroll
To scroll through the detections, use the Right and Left Arrow keys.
CH AN G I N G T H E U N I T S S E N SO R D AT A I S D I S P L A Y E D I N
Temperature can be displayed in Celsius (default unit) or Fahrenheit. Pressure
can be displayed in PSI (default unit) or meters (depth). Changing the units for a
sensor affects only the display of the data, it does not affect the data recorded by
the receiver. Data recorded by the receiver is always in the default units (Celsius
and PSI).
Change the unit for temperature via:
Codelog > 2)Scan > 1)Continue to log data > 2)View > 2)Temp, pressure units > 1)C/F