User's Manual

Guide to the SRX800 Receiver Preliminary
2)SC A N > 1)CO N T I N U E T O L O G D AT A
Actions available under this menu item are:
• Start a scan
• Delete all data from the receiver
ST A R T I N G A SC A N CY C L E
A scan cycle is initiated via:
Codelog > 2)Scan > 1)Continue to Log Data
Once a scan is started, no changes can be made to the active configuration, except
when the scan is paused. The only actions that can be taken at this point are:
AD J U S T I N G FR E Q U E N C Y AN D GA I N
Go to the next/previous applicable frequency
in the frequency table used by the active configuration using the Up or Down
Arrows.
A new gain can be selected using the Up or Down Arrows. The
amount of increment or decrement is specified by Set Delta for gain (see section
called Set Delta in chapter 1 for details).