User's Manual

Guide to the SRX800 Receiver Preliminary
Activity sensor type and the number 3 appears in the display. The display
automatically places a slash [/] between each selection (e.g. 1/2/3). After three
selections have been made, the receiver automatically returns to the Sensors
page. If fewer than three selections are made, press the Enter key to apply the
changes and return to the Sensors page.
SE T T I N G P A R AM E T E R S F O R T E M P E R AT U R E
Set the minimum temperature via:
Codelog > 1)Config > 6)Sensors > 3)Param > 1)C > 1)Min
Set the maximum temperature via:
Codelog > 1)Config > 6)Sensors > 3)Param > 1)C > 2)Max
Set the number of levels for temperature via:
Codelog > 1)Config > 6)Sensors > 3)Param > 1)C > 3)Level
To change the sign of a value for any of the parameters above, use the +/- key.
SE T T I N G P A R AM E T E R S F O R P R E S S U R E
Set the minimum pressure via:
Codelog > 1)Config > 6)Sensors > 3)Param > 2)PSI > 1)Min
Set the maximum pressure via:
Codelog > 1)Config > 6)Sensors > 3)Param > 2)PSI > 2)Max
To change the sign of a value for any of the parameters above, use the +/- key.
Set the number of levels for pressure via:
Codelog > 1)Config > 6)Sensors > 3)Param > 2)PSI > 3)Level
SE T T I N G P A R AM E T E R S F O R AC T I V I T Y
Set the minimum activity via:
Codelog > 1)Config > 6)Sensors > 3)Param > 3)Act > 1)Min
This value is typically set to “0” (not moving).
Set the maximum activity via: