User's Manual

• The receiver then returns to the radio master antenna and repeats the cycle
until either the scan is stopped, the battery expires, or all of the receiver’s
data memory is used
When an antenna is being scanned, the frequencies are scanned according to
their scan order (the order they were entered into the frequency table).
If an antenna group is designated as a master, then all of the
antennas/hydrophones in the group are scanned simultaneously.
When antenna priority is enabled, master antenna preview is disabled.
Assign an antenna priority via:
Codelog > 1)Config## > 4)Ant/Hydr > 5)Priority > 1)Freq/Ant
Selecting 1)Freq/Ant changes the priority between frequency and antenna. Watch
the first line of the display to know which setting is being applied.
SETTING THE RECEIVER T O U S E T H E ASP-8
The receiver needs to know if an ASP-8 is being used or not. Set the receiver to
use an ASP-8 via Codelog > 1)Config## > 4)Ant/Hydr > 1)Use ASP8 > 7)Yes or
9)No.