User's Manual

AS S I G N I NG A G AI N V AL U E T O TH E AN T E N N A P O R T O N T H E
F R O N T P AN E L
Assign gain values to each antenna via:
Codelog > 1)Config## > 4)Ant/Hydr > 4)Gain > 2)AH0 Gain
AS S I G N I NG GAI N VA L U E S T O MA S T E R AN T E N N AS
Assign gain values to master antennas via
Codelog > 1)Config## > 4)Ant/Hydr > 4)Gain > 3)Radio Master Gain (or) 4)Acoustic Master
Gain
If the master designation has been set for all radio antennas or hydrophones in
either the radio or hydrophone groups, then that gain value is used for all
members of the group.
SE T T I N G A S C AN P R I O R I TY
Three scan priorities are available: Frequency, Master Antenna Preview, and
Antenna. Antenna priority is completely independent of the other two, whereas
Master Antenna Preview always uses Frequency Priority first and then uses its
own rules to complete a scan.
US I N G FR E Q U E N C Y PR I O R I T Y F O R A S C AN
Frequency priority is used when it is desired to scan a single frequency using
every applicable antenna before moving on to the next frequency in the selected
frequency table. All valid detections of transmitters that occur during scanning
are recorded.
Frequency priority is, by default, always enabled, unless antenna priority is
enabled.
The antenna used to begin a scan depends on the type of frequency (radio or
acoustic) that was the first entered into the frequency table. If this frequency was