User's Manual

Guide to the SRX800 Receiver Preliminary
• Enter a value from 1 through 8 to make a single antenna the master. The
value entered corresponds to an antenna port number on the ASP-8.
• Enter the value as 9 to designate NO antenna as master
After a value has been entered, the receiver returns to the menu selections page.
AS S I G N I NG A HY D R O P H O N E M A S T E R
Assign a hydrophone to be the master hydrophone via:
Codelog > 1)Config## > 4)Ant/Hydr > 4)Hydr > 2)Acoustic Master Hydr
Three selections are possible:
• Enter “0” (zero) to make all hydrophones masters.
• Enter a value from 1 through 8 to make a single hydrophone the master. The
value entered corresponds to an antenna port number on the ASP-8.
• Enter “9” to designate NO hydrophone as master.
After a value has been entered, the receiver returns to the page of menu
selections.
AS S I G N I N G G AI N V A L U E S
The ASP-8 and all antennas must be assigned gain values. A typical starting gain
value is 50, but it should be set according to the requirements of the study.
AS S I G N I NG G AI N V AL U E S T O AN T E N N A P O R T S O N T H E ASP-8
Assign gain values to each of the Antenna Ports on the ASP-8 via:
Codelog > 1)Config## > 4)Ant/Hydr > 4)Gain > 1)ASP-8 Gain
Enter the number of the antenna port to provide a gain value for it. The display
then updates to prompt for a gain value. Immediately after the appropriate gain
value has been entered, the display returns to the ASP8 Gain page. Following the
ASP8 Gain title in the display is a series of numbers in brackets. These numbers
are the current gain value settings corresponding to an antenna port. They are
listed in order from one to eight.