User's Manual

All frequencies in a frequency table can be deleted via:
Codelog > 1)Config## > 3)Freq/CH > 2)View/Modify > 1)Del > 7)Yes (or) 9)No
EN AB L I N G /DI S AB L I N G AL L F R E Q U E N C I E S I N A FR E Q U E N CY
TAB L E
All frequencies in a frequency table can be enabled (available for scanning) or
disabled (skipped). During a scan all frequencies can be temporarily removed
from the scan cycle. By default, all frequencies entered are considered to be
enabled.
The receiver only scans frequencies that are enabled.
All frequencies can be enabled via:
Codelog > 1)Config## > 3)Freq/CH > 2)View/Modify > 2)EN
Press the END/ESC key to go back to the Freq/Ch page.
The display shows two values in brackets after the page title (e.g. AllFreq/Ch(2,
4)). These numbers in brackets correspond to four of the available menu items:
2)EN, 3)Dis, 4)ID and 5)Sen. The first number in brackets after the title indicates
whether the frequencies in the frequency table are enabled (2) or disabled (3).
The second number indicates whether the transmitter type in use is ID only (4) or
ID with Sensor (5). After a key (2, 3, 4, or 5) is pressed, the number in the brackets
changes accordingly.
AS S I G N I N G A TR A N S M I T T E R TY P E T O AL L FREQ/CH
The receiver defaults to the ID-only type for new frequency and channel
assignments; others must be specifically assigned.
Assign a transmitter type via:
Codelog > 1)Config## > 3)Freq/CH > 2)View/Modify > 3)ID/Sen
The display shows two values in brackets after the page title (e.g. AllFreq/Ch(2,
4)). These numbers in brackets correspond to four of the menu items available: