User's Manual

Guide to the SRX800 Receiver Preliminary
CRTO cannot be used if AGC is enabled, because gain must be fixed for the
duration of a data record.
EN AB L I N G /DI S AB L I N G T H E GPS CL O C K
When the receiver begins scanning, it can simultaneously update the GPS clock
as long as the GPS clock is enabled. This provides a higher time resolution for
data recorded by the receiver.
When the GPS clock is enabled, it comes on for five minutes, updating the clock
every second, and then it turns off for three hours. It repeats this cycle
continuously, until scanning is stopped. During a scan, the display flashes the
letter G to indicate that the GPS clock is enabled.
If the GPS clock is disabled, the GPS positioning feature is automatically
disabled.
Enable or disable the GPS clock via:
CodeLog > 1)Config## > 2)Scan Settings > 3)Options > 4)GPS > 1)En/Dis GPS Clk
The first line in the display shows the current setting and updates accordingly
when 1)En/Dis GPS Clk is selected.
EN AB L I N G /DI S AB L I N G GPS PO S I T I O N I N G
For the receiver to acquire a GPS position, this feature must be enabled.
The GPS clock must be enabled for the GPS positioning feature to work.
Enable or disable the GPS positioning feature via:
CodeLog > 1)Config## > 2)Scan Settings > 3)Options > 4)GPS > 2)En/Dis Position