User's Manual

Guide to the SRX800 Receiver Preliminary
Codes Sets are accessed via:
CodeLog > 1)Config## > 2) Scan Settings > 1)Code Set
Use the keypad to select the desired code set. If the receiver is Offline, then
accessing the codeset feature only provides current setting information.
Code sets can also be selected via: Manual > 1)Code Set.
SE T T I N G A SC A N TI M E
When collecting data, the receiver needs to know how long it should scan each
frequency and antenna combination. This is referred to as the scan time. Scan
times are typically set to the maximum transmitter burst interval plus 0.5
seconds. Scan time can be set with a resolution of 100ms. The range is 0.1s
through 99.9 seconds.
Set the scan time via:
Codelog > 1)Config## > 2)Scan Settings > 2)Param > 2)Scan Time. Scan time
format is in seconds.
SE T T I N G TO T AL SC A N TI M E
The total scan time is the maximum amount of time a complete scan cycle can
take, but the actual time to complete a scan cycle can be less than this, because
other settings, like TOA, may cause the receiver to adjust the scan time.
If a scan cycle takes less than the calculated total scan time calculated then the
receiver can be setup to wait until the total scan time has elapsed before it starts
another scan cycle. Setting the total scan time allows multiple receivers to
synchronize their scan cycles. It is a power-saving option—the receiver shuts
down all antennas and lowers their Gain while it waits for the total scan time to
elapse.
Set the Total Scan Time via:
Codelog > 1)Config## > 2)Scan Settings > 2)Param > 2)Total Scan Time
Total scan time format is minutes/seconds (mm/ss).