User's Manual

SE T DE L T A F O R GA I N
When incrementing gain manually (by using the keys on the keypad), the
receiver adds the Set Delta gain increment to the gain being used at the time the
gain is adjusted up or down.
Set this increment via: Manual > 2)Search > 1)Start > 3)Set Delta > 2)Gain
ST A R T I N G A GPS AC Q U I S I T I O N
To start acquiring a GPS 2D position, press the GPS key on the keypad (key
number 4). While attempting to acquire a position, the display shows the number
of satellites as they are found.
If a valid position is acquired, the following information is provided in the
display: Latitude, Longitude, current date, current GMT time, the number of
satellites used, HDOP, and PDOP. The display flips back and forth between
showing the Latitude and Longitude for four seconds and the satellites, HDOP,
and PDOP information for two seconds. Either the time or the date is also shown
on the display and is updated every five seconds.
GPS cannot be used if the receiver is logged off. However, it is possible to log
off from the receiver while the receiver is attempting to acquire a GPS position.
When logging back on, the display shows the results of the GPS position.
Press the END/ESC key to stop acquiring a GPS position.
AD J U S T I N G FR E Q U E N C Y AN D GA I N
A new frequency can be selected with the Up or Down arrows. The amount of
increment or decrement is specified by Set Delta for frequency (see the section
Set Delta in Chapter 1 for details).