User's Manual

• Configure communication settings (serial and modem)
• Reset communication settings to the default Factory Settings
• Enter the Local Date, Time, and GMT correction
• Reset or change the log on password
After the Setup key is pressed, the LCD shows three main menu items:
1)Comm, 2)Time, 3)Reset Password
This section is organized by these three menu items.
1)CO M M
CO N F I G U R I N G SE R I A L PO R T SE T T I N G S
The serial port must have its baud rate (for modem), parity, data bits, and stop
bits defined. If these settings are not changed, then the default values are used,
which are: Baud rate= 115200, Parity= No, Data bits= 8, and Stop bits= 1.
To define each of these parameters:
• Baud Rate: Select one of the nine different baud rates.
Setup > 1)Comm > 1)Configure > 1)Serial I (or) 2)Serial II > 1)Baud Rate
• Parity: Select to have no parity, odd parity, or even parity.
Setup > 1)Comm > 1)Configure > 1)Serial I (or) 2)Serial II > 2)Parity
• Data Bits: Select either 7 or 8 data bits.
Setup > 1)Comm > 1)Configure > 1)Serial I (or) 2)Serial II > 3)Data Bits