User's Manual

SHIFT

SET G

SHIFT

SET

SCAN

SET F is for frequency adjustment, SET G is for gain adjustment and SET SCAN is for scan time

adjustment. The currently active parameter is displayed by the delta status position character.

All adjustments remain in effect except the frequency adjustment which will be reset when the

receiver steps to the next channel. When SET SCAN is selected, the scan time is displayed in the

lower left corner of the display. If interval/rate measurement is on, the scan time will not be

displayed until an arrow key is pressed. The displayed scan time will be replaced by the interval

or rate at the next pulse.

The decimal point (.) key pauses and continues the scan. When paused, a colon (":") is displayed

the scan status position.

When scanning has been paused, you can manually step through the frequencies in the table by

pressing the key sequence:

SHIFT

SCAN

This key sequence assigns the arrow keys control of the scan direction (upward arrow is forward,

downward arrow is backward). This allows you to step quickly through the scan table in either

direction to find a particular frequency. Arrow key assignment is indicated by a double or single

arrow in the delta status position (arrow to right is forward, arrow to left is backward). If the

arrow keys are pressed while scanning is not paused, they will control the direction of automatic

scanning.

Frequencies may be removed from and restored to the active partition while scanning is in

progress using the key sequence:

SHIFT

F TABLE

This sequence assigns the arrow keys to delete (downward arrow) and restore (upward arrow)

functions. The assignment is indicated by a "+" character in the delta status position, which

changes on activation of either arrow key to a "+" or a "-" to indicate the last operation performed.

Restoration is applied on a "last deleted first replaced" basis. Frequencies which have been

deleted but not restored at the end of a scanning session may be restored collectively using the F

TABLE Copy option (see above).

SCAN key functions are summarized in the following table:

Key Sequence Direct Effect Arrow Keys Delta Status Scan Status

Stop/Start : - > or <-

SHIFT + SCAN

Scan up/

Scan down

<=> - > or < -