User's Manual

13
3) Copy
Selecting this option copies all frequencies, which have been temporarily deleted in SCAN mode,
back into the active partition. Frequencies deleted using the previous option cannot be restored
in this way and must be re-entered using the Add option. Copy is available only in configuration
2 and 3 Suretrack receivers.
4) Partition
This menu option allows you to select from up to eight (dependant on the Suretrack
Configuration number) separate frequency table partitions, numbered 0 to 7. When selected, the
following display appears:
Active Partition (0-15)
(0)>
The current or "active" partition is shown before the prompt and it is the default value assumed if
ESC or an invalid digit is pressed. Entry of a valid partition number redefines the active
partition to be used in SCAN mode.
5) Size
This menu option displays a count of all frequencies currently in memory in all tables (Master
Table Size), including those which have been temporarily deleted but not restored while in
SCAN mode, and a count of all frquencies currently in the designated partition (Partition Size) :
Master table Size = X
Partition Y Size = Z
F0
In the Suretrack receiver, this key has no assigned function.
F1
The F1 key is used to initialize the receiver when new firmware is installed or reinitialize the
receiver to the factory default settings at anytime. When pressed, the following message
appears:
NEW PROM Initializes
system variables...
Shortly afterwards, the display changes to a prompt:
NEW PROM Initializes
OK to proceed? 1)Y 2)N
If 2 or ESC is selected, the display returns to the power-on default. If 1 is selected, the receiver
prompts for an access code: