User's Manual

Lotek Biotracker Receiver User’s Manual Page 5
Storing Frequencies in Channels
• Start in Frequency mode and tune to the frequency to be stored
• Press [Store] to display the last used channel on the top line of the display
• Choose a channel using the up/down arrow keys, or enter a channel number
followed by [

].
• Press [Store] to save the frequency to the channel displayed on the top line. The
receiver will then be in Channel Mode on the chosen channel.
Scanning Mode
• Press [SCAN] to enter Scanning Mode. Two opposing curved arrows are shown on
the bottom right of the display. The top line shows the scan interval in seconds.
• Choose a scan interval by using the arrow keys or typing a number (up to 999).
Press [

] to accept.
• Press [

] again to display channels on top line of the display. Channels that are
selected for scanning show ‘SC’ in the top right of display.
• Toggle channel selection status (‘SC’) on/off by pressing [

]. Scroll through channels
using the arrow keys or type a channel number followed by [

] to see other
channels.
• To select all channels for scanning, press [DEL]. Pressing [DEL] again deselects all
channels without affecting individual channel selection status (‘SC’). When all
channels are selected for scanning, ‘AC’ is displayed.
• To start scanning press [SCAN].
• To stop scanning and return to the mode and frequency settings prior to scanning
press [X].
• To stop scanning and return to Channel Mode with last channel scanned press
[SCAN].