User's Manual

Lotek Biotracker Receiver User’s Manual Page 15

Scanning

The receiver has a Scanning Mode in which selected channels are automatically stepped

through in sequence at a user-definable time interval. There is no facility to

automatically detect signals in this mode (unlike an amateur radio ‘scanner’).

Initial Conditions

The receiver can be in either Frequency Mode or Channel Mode.

The frequencies to be scanned should already be stored in memory.

Step 1

Press to display the scanning interval

(in seconds) on the top line of

the display.

Step 2

Use to select the interval (in seconds, 1 - 999).

OR…

Enter the interval from the numeric keypad then

Step 3

Press to display channels on the top line of the display.

Step through the channels using the arrows

Select or deselect individual channels using

This toggles the channel selection and

shows the selection state in the top right of

the display (SC = channel selected for scanning, or blank = channel not selected).

Use to select or deselect all channels at once. The individual selection status

of each channel is not affected by ‘all channel’ deselection.