User's Manual

Page 12 Lotek Biotracker Receiver User’s Manual

Step-by-step instructions

This section of the manual explains step-by-step how to use the main functions of the

receiver. The functions covered are:

• Changing frequency

• Storing frequencies to memory channels

• Deleting channels

• Scanning

Changing frequency

Normally when entering a new frequency in Frequency Mode the three places to the left

of the decimal place (the MHz value) do not need to be changed.

Therefore you need only to use the up-down arrow keys

OR…

Enter the frequency from the numeric keypad then

If you wish to change the entire frequency, then press before entering the

MHz frequency from the numeric keypad.

Press when the desired frequency is displayed.

Using the arrow keys the frequency will change in steps of either 1 kHz or 0.1kHz (.001 /

.0001 MHz).

The step size (tuning resolution) is toggled by pressing