LOS01009 Mini 8IGHT-DB Buggy Manual
TUNING, ADJUSTING AND
MAINTAINING YOUR VEHICLE
• Examine your vehicle on a regular basis.
• Use a brush to remove dirt and dust.
• Look for damage to the suspension arms and other molded parts.
• Re-glue the tires to the wheels, if necessary.
• Use suitable tools to tighten fasteners.
• Make sure the camber and steering linkages are not bent. Replace any bent linkages.
• Adjust the Toe and Camber settings, if necessary.
• Remove the shocks and inspect them for damage. Rebuild the shocks if oil is leaking.
• Inspect electronics and batteries for exposed wires. Repair exposed wires with shrink-wrap
or replace the wire.
• Make sure the ESC and receiver are secure on the chassis. Replace the double-sided tape,
if necessary.
• Power on the transmitter. If the green LED is dim or off, replace the AA batteries
in your transmitter.
• Check the spur gear for wear.
SERVICE/REPAIR
RADIO/SPEED CONTROL & MOTOR
If any problems other than those covered in the troubleshooting section arise, please call the
appropriate electronics service department. They will be able to give the problem additional
specific attention and provide instructions for the solution.
MAINTENANCE
If any questions other than those covered in the troubleshooting or maintenance sections
arise, please call the appropriate Horizon product support department.
CLEANING
Performance can be hindered if dirt gets in any of the moving suspension parts. Use
compressed air, a soft paintbrush, or a toothbrush to remove dust or dirt. Avoid using solvents
or chemicals as they can actually wash dirt into the bearings or moving parts, as well as cause
damage to the electronics.
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE SOLUTION
Vehicle does not operate
Battery not charged or plugged in Charge battery/plug in
ESC switch not “On” Turn on ESC switch
Transmitter not “On” or low battery Turn on/replace batteries
Motor runs but rear wheels
do not rotate
Pinion not meshing with spur gear Adjust pinion/spur mesh
Pinion spinning on motor shaft Tighten pinion gear setscrew on motor shaft flat spot
Transmission gears stripped Replace transmission gears
Drive pin broken Check and replace drive pin
Steering does not work
Servo plug not in receiver properly Make sure the steering servo plug is connected to the receiver steering channel, noting proper polarity
Servo gears or motor damaged Replace or repair servo
Will not turn one direction Servo gears damaged Replace or repair servo
Motor does not run
Motor wire solder joint is damaged Resolder the motor wire with the proper equipment
Motor wire broken Repair or replace as needed
ESC damaged Contact Horizon Hobby Product Support
ESC gets hot
Motor over-geared Use smaller pinion or larger spur gear
Driveline bound up Check wheels and transmission for binding
Poor run time and/or sluggish
acceleration
Battery pack not fully charged Recharge battery
Charger not allowing full charge Try another charger
Driveline bound up Check wheels, transmission for binding
Poor range and/or glitching
Transmitter batteries low Check and replace
Vehicle battery low Recharge battery
Loose plugs or wires Check all wire connections and plugs
The front wheels oscillate The steering gain is set too high Turn down the steering gain
The front wheels turn the wrong
way when the car slides/rotates
The steering channel was reversed after
calibration
Rebind and calibrate
The throttle does not reduce when
the car slides/rotates
The steering channel was reversed after
calibration
Rebind and calibrate
EN
8
LOSI MINI 8IGHT-DB RTR • INSTRUCTION MANUAL
EN
8
LOSI MINI 8IGHT-DB RTR • INSTRUCTION MANUAL