Operation Manual

NSTRUCTION

ANUAL

on attaching/removing the watch band

NRFBX

8-2002

The watch band is easy to change.

Follow the instructions below to remove or attach the

band to the watch. Use the enclosed tool for this

purpose.

■ How to remove the separate type band

Caution

Be careful of your fingers when handling the

tool.

Warning

Keep the small parts (push-pins etc.) away

from children. If a child swallows any of them,

consult the doctor immediately.

❖ The reverse procedures will be applied in order to attach the separate type band.

1. Place the tip of the tool to the projecting edge of

the push-pin.

2. Press it down. (With its inserted spring,

the push-pin is shrinkable.)

3. The band will be easily removed.

❖ Use the two-forked end of the tool to attach and remove the push-pin.

PAGE 1
8-2002 NRFBX ■ How to remove the separate type band ❖ Use the two-forked end of the tool to attach and remove the push-pin. 1. Place the tip of the tool to the projecting edge of the push-pin. INSTRUCTION MANUAL on attaching/removing the watch band 1 2 The watch band is easy to change. Follow the instructions below to remove or attach the band to the watch. Use the enclosed tool for this purpose. 2. Press it down. (With its inserted spring, the push-pin is shrinkable.) 3.
PAGE 2
■ How to attach the one-piece band ❖ Use the two-forked end of the tool to attach and remove the push-pin. 2 3 4 5 1 1. Set the push-pin into the watch head by using the tool. ❖ To attach the push-pin to the watch head, refer overleaf ■ How to remove the separate type band. 2. Pass the band underneath the watch head. ❖ The reverse procedures will be applied in order to remove the one-piece band. 3. Pull down the band. 4. Pass the band through the ring. 5. Pull the band down once again to fasten.