Owner's Manual

47
Using the Main Menu
2 Configure the following beside the desired
channel:
• Vi
deo: Sel
ect Enabled or Disabled. If you
select Disabled, you will not be able to view
the channel when connecting remotely to
the system.
• FPS: Select the desired frames per
sec
ond.
• Bitrate: Sel
ect the desired video bitrate.
• Audio: Sel
ect or deselect the checkbox to
enable or disable the system from
streaming audio when viewing the system
remotely.
3 Click A
pply to save your settings.
Setting up Email Notification
The system can send email notifications
when it detects motion or when an
alarm parameter triggers.
To set up email notification:
1 Click the Email tab in the
Network menu.
2 From the Email drop-down menu, select
from:
• Default: Uses the Lor
ex email server to
send out alarm notifications. This is the
recommended selection.
• Enable: Uses cus
tom email server
settings.
• Disable:
Disables email notification.
If you want to use Lorex’s email
server
(recommended):
1 In the Emai
l drop-down menu, select
Default.
Select Default
2 In the Sender Email field, enter the email
address of the sender. This can be any
email address of your choice.
3 In the Rece
iver Email field, enter the
email address you want the DVR to send
alarm notifications to.
4 In the Interv
al dr
op-down menu, enter the
Duration the DVR must wait before
sending out a new notification. 

For example, if you select a 3 minute
interv
al, the DVR will send out email
notifications every 3 minutes until the DVR
stops detecting motion / alarm. The DVR
will only send out notifications when it
detects motion/alarm triggers.
5 Click Apply
to save your settings.
If you select "Enable", and want to use
yo
ur own email server:
1 Configure the
following:
• SSL: Sel
ect ON/OFF to enable/disable
Secure Socket Layer protocol.
• SMTP Port: Ent
er your SMTP address.
• SMTP Server
: Enter your SMTP Server.
• Sender Email: Ente
r the sender email
address. This can be any address of your
choice.