Owner's Manual

24
Changing Protocol Information
5.3 SETTING THE CAMERA PROTOCOL AND BAUD
RATE
The protocol is the language that allows the camera and DVR to
communicate, and the baud rate is the frequency of signal sent to the
camera. The camera supports Pelco-D and Pelco-P protocols.
Protocol and baud rate are set using switches 1&2 on the smaller DIP
switch panel. See the table below.
Protocol and Baud Rate Switches
1 2 Protocol/Baud Rate
OFF OFF Pelco-D 2400
ON OFF Pelco-D 9600
OFF ON Pelco-P 4800
ON ON Pelco-P 9600
Switches 3& 4 are for manufacturer use only and
should always be set to OFF.
IMPORTANT