User`s guide

15
Configuring your video monitor
Adjusting the temperature unit of measurement
The camera has a built-in temperature
sensor. You can change the video monitor to
display temperature in Fahrenheit (F) or
Celsius (C).
To change the unit of measurement:
1 Press the Me
nu button on the video monitor.
2 Select Settings (
) and press the OK
button.
3 Select Tem
p. Display and press the OK
button.
4 Select either C fo
r Celsius or F for
Fahrenheit.
5 Press the OK b
utton to save your settings.
Configuring the temperature alert range
You can configure the video monitor to alert you
through alarm beeps, when the temperature
goes above or below the
set temperature range.
NOTE: T
emperature sensor is accurate within
3°F/1
°C.
NOTE: The L
W
2401AC2 accessory camera does
not have a temperature sensor. When this
camera is selected, the temperature
reading is permanently set to 68°F/20°C.
To configure the tempe
r
ature alert range:
1 Press the Me
nu button on the video monitor.
2 Select Settings (
) and then press the OK
button.
3 Select Tem
p. Alert and then press the OK
button.
4 Using the
jo
ystick, press up/down to change selection, left/right to adjust the values:
• Beside Low Temperature, enter the lowest room temperature threshold.
• Beside High T
emperature, enter the highest room temperature threshold.
5 Select the ON butt
on and then press OK.